Spec : gene(esp32s3)

gene 仕様詳細

• MCU ESP32-S3-WROOM-1-N16R8(下記参照)
• Battery 3.7V/400mAh
• USB USB TYPE-C (USB 2.0 FS)
• MicroSD Slot × 1
• Buttons リセット、電源
• LED RGB × 1, Charge LED × 1
• Connector * Sensor Module用 Connector
  (ESP32-S3の以下の12ピンに接続可能で、SPI,I2C,GPIO,ADCなどが利用可能です。
  IO1~IO3, IO7~IO9, IO21, IO35~IO38, IO46)
  * JTAG interface (ランドのみ)
• etc RGB LED、アクションカムマウント
• Size 本体: 40mm × 40mm × 19mm

gene Pin 機能表 esp32-s3-wroom-1_wroom-1u_datasheet_en.pdfより抜粋

• PIN TYPE FUNCTION
• 3V3 Power Supply 3.3V
• GND Power Supply GND
• IO1 Input/Output/High Impedance RTC_GPIO1, GPIO1, TOUCH1, ADC1_CH0
• IO2 Input/Output/High Impedance RTC_GPIO2, GPIO2, TOUCH2, ADC1_CH1
• IO3 Input/Output/High Impedance RTC_GPIO3, GPIO3, TOUCH3, ADC1_CH2
• IO7 Input/Output/High Impedance RTC_GPIO7, GPIO7, TOUCH7, ADC1_CH6
• IO8 Input/Output/High Impedance RTC_GPIO8, GPIO8, TOUCH8, ADC1_CH7, SUBSPICS1
• IO9 Input/Output/High Impedance RTC_GPIO9, GPIO9, TOUCH9, ADC1_CH8, FSPIHD, SUBSPIHD
• IO21 Input/Output/High Impedance RTC_GPIO21, GPIO21
• IO35 Input/Output/High Impedance SPIIO6, GPIO35, FSPID, SUBSPID
• IO36 Input/Output/High Impedance SPIIO7, GPIO36, FSPICLK, SUBSPICLK
• IO37 Input/Output/High Impedance SPIDQS, GPIO37, FSPIQ, SUBSPIQ
• IO38 Input/Output/High Impedance GPIO38, FSPIWP, SUBSPIWP
• IO46 Input/Output/High Impedance GPIO46

Module（ESP32-S3-wroom-1）仕様詳細

• CPU Xtensa®
  dual-core 32-bit LX7 microprocessor (with singleprecision FPU), up to 240 MHz
• Memory 384 KB ROM
  512 KB SRAM
  16 KB SRAM in RTC
  16 MB PSRAM
• WiFi 802.11 b/g/n
  Bit rate: 802.11n up to 150 Mbps
  A-MPDU and A-MSDU aggregation
  0.4 μs guard interval support
  Center frequency range of operating channel:2412 ~ 2484 MHz
• Bluetooth Bluetooth LE: Bluetooth 5, Bluetooth mesh
  Speed: 125 Kbps, 500 Kbps, 1 Mbps, 2 Mbps
  Advertising extensions
  Multiple advertisement sets
  Channel selection algorithm #2
  Internal co-existence mechanism between Wi-Fi and Bluetooth to share the same antenna
• Peripherals GPIO, SPI, LCD interface, Camera interface, UART, I2C, I2S, remote control,
  pulse counter, LED PWM, full-speed USB 2.0 OTG, USBSerial/JTAG controller,
  MCPWM, SDIO host, GDMA, TWAI® controller (compatible with ISO11898-1),
  ADC, touch sensor, temperature sensor, timers and watchdogs
  gene では全ての機能をご利用頂ける訳ではございません。
• Integrated Components 40 MHz crystal oscillator
  Up to 16 MB Quad SPI flash
• Antenna On-board PCB antenn
• Operating Conditions Operating voltage/Power supply: 3.0 ~ 3.6 V
  Operating ambient temperature:
  • – 65 °C version: –40 ~ 65 °C
  • – 85 °C version: –40 ~ 85 °C
  • – 105 °C version: –40 ~ 105 °C
• Certifications RF certification: link
  Green certification: RoHS/REACH